- 1 What kind of wood is used for epoxy river tables?
- 2 How much epoxy resin do I need for a river table?
- 3 How do you prepare wood for epoxy?
- 4 What is the best epoxy resin for river tables?
- 5 Is casting resin the same as epoxy resin?
- 6 How do I calculate how much epoxy resin I need?
- 7 How much does a resin table cost?
- 8 How do I calculate how much resin I need?
- 9 Can you use deep pour epoxy on table top?
- 10 How deep can you pour table top epoxy?
What kind of wood is used for epoxy river tables?
The best material to use for an epoxy resin table is typically the flattest piece of live edge wood you can find – such as Yew, Elm, Oak or Black Walnut – that has been properly air dried so the moisture level is below 20%.
How much epoxy resin do I need for a river table?
You’ll need close to 1-4 gallons of epoxy to cover a river table, depending on the space in between the table. For coating, two resin types are used to cover the table-top, which are the coating and casting resins.
How do you prepare wood for epoxy?
Before applying epoxy, sand smooth non-porous surfaces—thoroughly abrade the surface. 80-grit aluminum oxide paper will provide a good texture for the epoxy to “key” into. Be sure the surface to be bonded is solid. Remove any flaking, chalking, blistering, or old coating before sanding.
What is the best epoxy resin for river tables?
ProMarine Supplies Crystal Clear Tabletop Epoxy Resin – Your Best Choice for Wooden Countertops and River Tables. Our first pick is by far the easiest and most reliable epoxy resin on the market. ProMarine Supplies Tabletop Epoxy is a high-performance, crystal-clear epoxy coating that goes on in two easy steps.
Is casting resin the same as epoxy resin?
Epoxy coating resin has a more viscous consistency as compared to casting resin. It dries or cures faster than casting resin. Compared to casting resin, epoxy coating resin has relatively shorter processing times. Epoxy coating is more resistant to mechanical influence as compared to casting resin.
How do I calculate how much epoxy resin I need?
The calculation for determining the amount of epoxy you need is a simple volume calculation. You simply multiple the length of the pour by the depth of the pour by the average width of the pour and then convert to liters.
How much does a resin table cost?
Well, depending on the size of the table, it can run you anywhere from $50 all the way to $2000. Most coffee or end tables will cost within the $50-$200 range, a desk will be roughly $200-$500, while most dining tables are going to be $500+.
How do I calculate how much resin I need?
For the times when you want to be more exact, or if you are trying to calculate the amount of resin to go on a flat surface like a painting, you can take measurements of the area and figure out the volume of resin needed by multiplying the length times width times height.
Can you use deep pour epoxy on table top?
UltraClear Deep Pour Epoxy has a “softer” overall finish and is susceptible to scratching and denting if left as the stand-alone final coat. When using over a wear-surface such as a table or bar top, it is necessary to top-coat using one of our other products (i.e. UltraClear Bartop Epoxy or Osmo finishes).
How deep can you pour table top epoxy?
Don’t exceed the maximum pour depth, which is typically 1/8” to ¼” per layer for table top epoxy systems. Mix only as much epoxy as you need for the layer you are pouring. Make sure the temperature in your work area doesn’t exceed 80°F.