FAQ: How To Make A Floating Wood Mantel?

Can you use a floating shelf as a mantle?

For those of you that haven’t opened up your Kreg Jig yes, this is a GREAT beginner project! The shelf is 60″ long making it a perfect mantle as well! I also think floating shelves are perfect for renters. Really you only leave a few screw holes in the wall that are very easy to fill and paint back over.

What is a floating mantel shelf?

As the name suggests, a floating mantel is a fireplace mantel that appears to be floating on your wall, usually above a fireplace. Floating wood mantels are typically hung at a height of 54 in. to 64 in.

How do you remove a floating mantel?

Pound the bottom of the mantel shelf with a rubber mallet to separate it from the wall if it doesn’t release when you pry the base of the mantel away from the wall, advises Fireplace Town. Tap it gently, but with enough force to pull the nails from the wall. Once it’s loosened, pull out on the shelf to remove it.

How do you attach a floating mantel to a stone fireplace?

Slide Over Bolts Method

  1. Locate the studs behind the brick, stone, or faux veneer.
  2. Drive 1/2in lag screws through each of the studs.
  3. Have a helper support the mantel while you mark the location of the support rods on the back of the beam.
  4. Apply construction adhesive into the holes.
  5. Slide into place, admire, and enjoy!
You might be interested:  Quick Answer: How To Make Wooden Drawers Slide Better?

How do you install a floating mantel on drywall?

Holding your drill at a 45 degree angle downward, drill a pilot hole through the shelf and drywall and into the stud. Install a finishing nail into each of the pilot holes with a nail gun or hammer; the nails must be long enough to penetrate at least 1 inch into the drywall. These nails will secure the mantle in place.

How far should a mantle stick out?

The proportions of your mantel in relationship to your fireplace are important. Generally, your mantel should extend a minimum of three inches beyond the opening of your fireplace.

Do you install mantel before or after stone?

It’s best to build the mantel right into the stone, rather than refinishing the fireplace first.

How do you make a homemade mantel?

Instructions

  1. Cut the 10″ boards to the appropriate length.
  2. Use wood glue and finishing nails to attach the two boards together.
  3. Cut this board to the length of your mantel.
  4. Attach with wood glue and finishing nails.
  5. Cut a board to size to fill the gap on the bottom of the mantel.

How do you seal a wood mantel?

Prime the wood with either a clear or white primer. Apply the specific stain or color of paint you desire. Minwax Sanding Sealer is a good sealer to apply after a stain or color, though it will be quite slick looking. Seal whichever sealer you use with a coat of Minwax Polyurethane to ensure the mantel is protected.

What type of wood is used for mantels?

Softwood. In most cases, hardwood is the best type of wood to use for mantels above fireplaces. Because of its hardness, it’s durable and lasts for years while maintaining the appearance of newness.

Leave a Reply

Your email address will not be published. Required fields are marked *